Wide enough for two at 49.5 inches across, this Adirondack is molded from high density polyethylene rather than cut from timber, so it will not split after a summer in direct sun. Every joint is fixed with 304 stainless steel screws, the fastener most likely to outlast the seat itself near salt air. The backrest reclines at 103 degrees, a deep angle that follows the spine, and the seat is oversized with broad armrests on both sides. Height and depth both run 34 inches with a 15 inch seat height, and the loveseat carries up to 660 lbs. HDPE needs no staining or sealing: soap and water handle dirt, and the color runs through the material instead of sitting on top as paint. Net weight is 59.5 lbs.